How to Fix Mac Error Code 50

Although it’s a user-friendly interface, Mac OS X sometimes gives no additional information than an error code when a bit goes wrong. One of these is Mac error code 50, which may happen when you try to move, delete files, or copy from external hard drives.

If this happens and you are trapped with a folder you cannot manage, after that, you can likely conquer this error only with some possible approaches.

What causes the Mac Error Code 50?

When your Mac is receiving the error code 50, it can be difficult to determine instantly the appropriate troubleshooting solution because there are many factors that are next to play here. There are many errors, Mac error code 50 is one of the errors from the Mac error codes list.

Here are a few possible causes of Mac error code 50:

1. Corrupted System Files or Programs
2. Outdated System or Software
3. Misconfigured System Settings
4. Hardware Related Problems
5. Junk or Cache Files

Before trying some of the further advanced fixes we methods below, you should begin with a simple restart. In case the Mac error code 50 is caused by a folder that’s stuck in a dividing line condition, rebooting your PC will clear the impermanent memory which will end up fixing this problem.

Here are some guaranteed working techniques to fix Mac error code 50:

1. Check your drive by using Disk Utility

First, make sure the drive’s formatting is okay, with Disk Utility to run a confirmation routine on the storage capacity that holds the file.

2. Re-mount and Un-mount your device

Since a general as well as less-intrusive approach, you can as well try ejecting your drive, pursued by unplugging it. After that reboot your PC, and then plug your drive in again when it mounts, try managing the file on it.

3. Rename the file

One quick solution to this issue is to try to rename the file.

4. Resetting PRAM and AVRAM

If the above operations didn’t allow you to fix Mac error code 50 or a message could not be sent error code 50 Mac, the issue in your case is most likely rooted in PRAM (Parameter RAM) or NVRAM (Non-Volatile Random Access Memory).

5. Formatting drive to FAT 32

A further fairly common cause that might make possible the process of the Mac Error code 50 is a mismatched file nature used for the moveable storage device used while trying to move or copy data. In a good number of reported cases, this issue will occur because of the reality that the flash drive /SSD / HDD is formatted to NTFS.

Conclusion

Getting the Mac Error Code-50 or mac error code -50 deleting file on your system can be really annoying as you’re stuck with the files that you can’t either copy or move. If you encounter this error, you can try the above fixes to resolves your case.

Source: https://reduxzones.wixsite.com/tech-blogs/post/fix-mac-error-code-50